BEFORE USING YOUR KEG COOLER
• Remove the exterior and interior packaging.
• Check to be sure you have all the following parts:
• 2 Safety Guard Rail
• 1 drip tray (2 pieces)
• 1 CO
2
Cylinder support
• 1 CO
2
Regulator
• 1 CO
2
Empty Cylinder
• 2 CO
2
Gas line hose (coloured)
• 2 Beer Hose
• 2 Beer keg couplers
• 1 Beer tower
• 2 Pull handle (Beer tower faucet)
• 4 Plugs: For guard rail holes
• 1 metal plate for cabinet bottom
• 3 Wire shelf
• 2 steel clamp for coloured hose
• 2 plastic washers for front casters
• 4 Casters (2 front with locks)
• Before plugging in the keg cooler, let it stand upright for approximately 6 hours. This will reduce
the possibility of a malfunction in the cooling system from handling during transportation.
• Clean the interior surface with lukewarm water using a soft cloth.
5
INCLUDED ACCESSORIES
Remove and inspect all accessories supplied with this unit and ensure they are all present and in
good condition. In the event any of the accessories are missing and/or not in good condition, please
call Danby toll free at
1-800-263-2629
and speak with one of our Consumer Service Representatives.
1. Beer Tower
2. Rubber Gasket
(may not be
required in all unit confi gurations)
3. Safety Guard Rail
4. Drip Tray
5. Adjustable Thermostat
6. CO
2
Regulator
7. CO
2
Gas Cylinder
8. CO
2
Gas Cylinder Support
9. Evaporator
10. Door
11. Beer Keg
(not included)
12. Metal Plate
13. Castors (4)
Installation Instructions
