INSTALLATION OF THE BEER TOWER
• Remove the plug from the top of the fridge
cabinet by twisting and pulling out. Save the
plug for later use to convert the appliance to a
refrigerator.
• Unravel the beer lines (clear hoses) from the
tower and insert the beer lines and wing nuts
through the uncovered hole on top of the
cabinet.
• Secure the beer tower assembly to the top of the
cabinet by pressing down and turning the tower
to lock in place. Ensure the faucet is aligned with
the front of the appliance.
• The rubber gasket can be used to make the
connection between the tower and the cooler
tighter if needed. If the beer tower will not turn
to lock in place, try removing the rubber gasket.
The rubber gasket may not be required in all
confi gurations.
Note:
If the faucet is leaking or if the beer is very
foamy, ensure that the washers inside the faucet are
intact. Replace the washers with spare parts from
the accessory bag, if necessary.
1. Handle washer
2. Tap washer
3. Spout washer
INSTALLATION INSTRUCTIONS
FAUCET WRENCH
The provided faucet wrench is for either removing or tightening the faucet connection. If the beer is not
fl owing freely, use the wrench to remove the faucet for cleaning. If the faucet connection is leaking, use the
wrench to tighten the faucet connection.
PLASTIC FAUCET HANDLE
Attach the black plastic handle to the top of the faucet. Hold the silver nut underneath so it does not turn.
If there is a small drip from the faucet, the silver nut may be overtightened. Unscrew silver nut counter-
clockwise by one turn.
INSTALLATION OF THE PROTECTIVE METAL PLATE
The protective metal plate should be installed on the bottom of the inside of the cabinet. This plate should
always be installed when a keg is in place to protect the fl oor of the cabinet from damage.
INSTALLATION OF THE BEER KEG
• Two people should lift the keg to avoid back injury
• Position the keg directly in front of the open door.
• Using the keg handles, lift the front of the keg just enough so the front end is resting on the front edge
of the keg cooler bottom cabinet.
• Grasp the keg handles and slide it all the way into the cabinet.
8
