BEER TOWER
ASSEMBLY
BACK
1
3
2
4
5
6
7
8
9
10
11
12
13
Features
INCLUDED
ACCESSORIES
Remove and inspect all accessories supplied with this unit. Ensure they
are all present and in good condition. In the event any of the accessories
are missing and / or not in good condition, please call Danby TOLL FREE
at the number listed below and speak with one of our Consumer Service
Representatives.
(1-800-263-2629)
1
.
Beer Tower
2.
Plastic Gasket
3.
Safety Guard Rail
4.
Drip Tray
5.
Adjustable Thermostat
6.
CO2 Regulator
7.
CO2 Gas Cylinder
8.
CO2 Gas Cylinder Support
9.
Evaporator
10.
Reversible Door
11.
Beer Keg (not included)
12.
Metal Plate
13.
Metal Washers(2)
14.
Castors with Lock (4)
5
CHILL N’TAP ACCESSORIES
BEFORE USING YOUR
BEER DISPENSER
• Remove the exterior and interior packaging.
• Make sure you have all the following parts:
• 1 Safety Guard Rail
• 1 drip tray (2 pieces)
• 1 CO2 Cylinder support
• 1 CO2 Regulator
• 1 CO2 Empty Cylinder
• 1 CO2 Gas line hose
(coloured)
• 1 Beer Hose
• 1 Beer keg couplers
• 1 Beer tower
• 1 Pull handle (Beer tower faucet)
• 4 Plugs: For guard rail holes
• 1 metal plate for cabinet bottom
• 2 Wire shelves
• 1 steel clamp for coloured hose
• 2 metal washers for front casters
• 4 Casters (2 front with locks)
• Before plugging in the keg cooler, let it stand upright for approximately 2 hours. This
will reduce the possibility of a malfunction in the cooling system from handling during
transportation.
• Clean the interior surface with lukewarm water using a soft cloth.
