BEFORE YOU BEGIN
Read these instructions completely and carefully.
Installation of this range must conform with local codes, or in the absence of local codes, with the National Fuel Gas
Code, ANSI Z223.1/NFPA 54, latest edition. This range has been design-certi
fi
ed by CSA International according to ANSI
Z21.1, latest edition.
As with any appliance using gas and generating heat, there are certain safety precautions you should follow. You will
fi
nd
these precautions in the Important Safety Information section in the front of this manual. Read them carefully.
IMPORTANT
- Save these instructions for local electrical inspector’s use
IMPORTANT
- Observe all governing codes and ordinances.
Note to Installer
- Leave these instructions with the appliance after installation is completed.
Note to Consumer
- Keep this Owner’s Manual and Installation Instructions for future reference.
Note -
This appliance must be properly grounded.
Servicer -
The electrical diagram is attached to the back of the range.
Mobile home - additional installation requirements:
The installation of this range must conform to the
Manufactured Home Construction and Safety Standard, Title 24 CFR,
Part 3280
(formerly the Federal Standard for Mobile Home Construction), use the Standard for Manufactured Home
Installations, ANSI A225, 1/NFPA 501A or with local codes.
Mobile home installations require:
When this range is installed in a mobile home, it must be secured to the
fl
oor during transit. Any method of securing the
range is adequate as long as it conforms to the standards listed above.
The oven light bulb is covered with a removable glass cover that is held in place
with a bail-shaped wire. Remove the oven door, if desired, to reach the cover
easily.
Be sure to let the light cover and bulb cool completely.
To remove the cover:
1. Hold a hand under the cover so it doesn’t fall when released. With the
fi
ngers
of the same hand,
fi
rmly push back the wire cover holder. Lift off the cover.
Do
not remove any screws to remove the cover.
2. Do not touch the hot bulb with a wet cloth. Replace the bulb with a 40-watt
appliance bulb.
To replace the cover:
1. Place it into the groove of the light receptacle. Pull the wire forward to the center of the cover, until it snaps into place.
When in place, the wire holds the cover
fi
rmly. Be certain that the wire is in the depression in the center of the cover.
2. Connect the electrical power to the range.
Wire cover holder
OVEN LIGHT REPLACEMENT (on some models)
In the Commonwealth of Massachusetts:
•
This product must be installed by a licensed plumber of gas
fi
tter.
•
When using ball type gas shut-off valves, they shall be the T-handle type
• A
fl
exible gas connector, when used, must not exceed 3 feet.
19
Wire cover holder
CARE AND MAINTENANCE
INSTALLATION INSTRUCTIONS
