INSTALLATION INSTRUCTIONS
LOCATION
Do not lcoate the range where it may be subject to strong drafts. Any openings in the
fl
oor or wall behind the range should
be sealed. Make sure the openings around the base of the range that supply fresh air for combustion and ventilation are
not obstructed by carpeting or woodwork.
Your range, like many other household items, is heavy and can settle into soft
fl
oor coverings such as cushioned vinyl or
carpeting. Use care when moving the range on this type of
fl
ooring. It is recommended that the following simple and inex-
pensive instructions be followed to protect your
fl
oor.
The range should be installed on a sheet of plywood (or similiar material). When the
fl
oor covering ends at the front of the
range, the area that the range will rest on should be built up with plywood to the same level or higher than the
fl
oor cover-
ing.
This will alow the range to be moved for cleaning or servicing. Also,make sure your
fl
oor covering will withstand 180° F.
(See the Installation Safety Instructions section.)
Make sure the cabinets and wall coverings around your range can withstand the heat generated (up to 200° F) by the
range. (See the Installation Safety Instructions section).
IMPORTANT!
Remove all tape and packaging. Make sure the burners are properly seated and level.
Take the accessory pack out of the oven and/or drawer.
Check to be sure that no range parts have come loose during shipping.
23
INSTALL THE ANTI-TIP BRACKET
STEP 1 LOCATE THE BRACKET
IMPORTANT:
Determine the
fi
nal location of the range before attempting to install the
bracket.
Place the bracket on the
fl
oor with the back edge against
the rear wall. If the range does not reach the rear wall,
align the back edge of the bracket with the rear panel of
the range in its
fi
nal location.
Rear Wall
Adjacent cabinet or
final location of right
range side panel
Loc. A
Loc. B
Two screws must enter floor
or wall at Loc. A or B.
IMPORTANT:
If the bracket does not touch the rear wall, you MUST
screw the bracket to the FLOOR as described in Step 2.
Position the side of the bracket against the right cabinet. If
there is no adjacent cabinet, align the edge of the bracket
with the right side panel of the range in its
fi
nal location. If
the countertop overhangs the cabinet, offset the bracket
from the cabinet by the amount of the overhang.
A
B
Mark the location for the pair of holes to be used (see illustration above).
NOTE:
For FLOOR installation use Loc. A. For REAR WALL installation use Loc. B.
C
Rear wall
Two screws must enter
fl
oor or wall at Loc. A or B.
Adjacent cabinet
or
fi
nal location of
right range side
panel
Loc. B
Loc. A