5
OPERATING INSTRUCTIONS
DOOR REVERSAL INSTRUCTIONS
If the appliance is placed on its back or side for any
length of time it must be allowed to remain upright
for 6 hours before plugging it in to avoid damage
to the internal components.
1. Open the door to a 90° angle and remove
the hinge screws. Slide the bottom of the door
outward to remove it from the cabinet.
2. Remove lower hinge from the cabinet. Remove
the upper right hinge from the cabinet. Remove
the axis plate from the door. Remove the door
stop from the bottom right side of the door.
Remove the actuator from the bottom of the
door.
3. Remove the screw hole covers from the top left
of the cabinet and install them in the screw holes
on the top right side of the cabinet. Install the
upper left hinge.
4. Turn the lower hinge over and install it on the
lower left side of the cabinet.
5. When reinstalling the door, it will need to be
fl ipped 180° from its original position to ensure
that the handle is on the correct side. Install the
actuator at the top of the door frame. Screw
holes can be found by gently pulling back the
rubber gasket. Install the axis plate and the door
stop on the upper right side of the door.
6. Flip the door 180° and install it on the cabinet
by sliding it onto the upper hinge and sliding the
bottom of the door toward the cabinet. Before
securing the hinge screws ensure the top of
the door is properly aligned with the top of the
cabinet, that the actuator is making contact with
the switch on the cabinet and that the rubber
gasket makes a good seal with the cabinet all
the way around.
1
2
3
4
a
d
b
c
e
f
f
g
h
a
d
b
c
e
5
a. Hinge screws
b. Axis plate
c. Lower hinge
d. Door stop
e. Actuator
f. Upper right hinge
g. Screw hole covers
h. Upper left hinge
