重心位置展示
5
09
Set and Adjust
设置和调试
Display the C.G
注意：设置重心时，可用电池配重，调整电池
位置以达到合适的重心。然后用魔术胶带把电
池固定在仓身内。
Note:When you adjust CG, you can use battery
as balance weight, adjust battery positon to
find the suitable CG, then fasten the battery on
the cabin with magic tape.
Control Directions Tests
Elev
at
or
升降舵
方向舵
副翼
Ailer
on
Rud
der
遥控器动作
飞机反应
升降杆下拉
Direction rod to the left
升降杆上推
Direction rod to the right
Steering rod to the left
Steering rod to the right
Lifting rod up
Lifting rod down
转向杆向右
转向杆向左
方向杆向右
方向杆向左
地面控制方向测试
常规飞行(Normal Flying) 3D飞行 部分飞机支持(3D Flying only support some models)
副翼 Aileron ±（15°-30°） ±40° 或者更大(or larger)
平尾 Elevator ±15° ±40° 或者更大(or larger)
垂尾 Rudder ±15° ±40° 或者更大(or larger)
常用襟翼 Flap （起飞 take-off）15°-20° （降落 Landing）20°-40°
部分特殊机型会有V型尾翼，襟翼，前缘机翼或舵面很小等，可以以常规飞行的角度作为参考，在您不确认且没有有经验人员指导
的情况下，我们建议您先以小角度试飞以确认您的设置是否正确。
Some special models will have V-tails, flaps, leading edge wings, etc., which can be used as a reference for conventional
flight angles. If you do not confirm and there is no experienced person to guide you, we recommend that you first test
at a small angle to confirm that your settings are correct.
Rudder
Elevator
Aileron
20°-35°
25°
25°
25°
25°
20°-35°
通常情况下，舵面角度的设置如下：
Usually, the control throws set as below:
≈70-75mm
升降舵
副翼
方向舵
当前缘缝翼 Leading Edge Slat 紧贴机翼时 速度保持不变 升力保持不变。
当打开一定角度的前缘缝翼时，速度减慢，升力提升。（注意不要设置开启角度过大，当角度太大时，速度过慢，升
力会减小。）
When the leading edge slat is close to the wing, the speed remains the same and the lift remains the same.
When the leading edge slat is opened at a certain angle, the speed decreases and the lift increases. (Be
careful not to set the opening angle too large. When the angle is too large, the speed will be too slow and
the lift will decrease.)
前缘缝翼
Leading Edge Slat
C.G
≈70-75mm
G3
自攻螺丝
Self-tapping screw
G4
粘固 stick firmly
M2*10mm 自攻螺丝
M2*10mm Self-tapping screw
