15
14
Manual
Manual
-
places of
installation of angles
for further fastening
of covering to an en
Fig. 1.8
Fig. 2
2кн
2к
2к
2кн
General view of the end
wall and location of the
angles for fastening of
polycarbonate.
Assembly is carried out
according to the
fig. 2.
Installation of runners
on the end wall.
STAGE 2
The assembled end wall is
installed in the horizontal
plane. To arcs
4 and 20
and girders of the end wall
are alternatively joined
end runners
2к и 2кн
align
the side flanges of shapes.
Runners deviate from the
vertical under their own
weight and abut against
side walls of shapes of arcs
4 (until the next operation).
bolt
angle
fig 4.2
Installation of longitudinal
stiffness side braces.
STAGE 4
Fig. 4.1
2к
укос
укос
STAGE 3
Assembly of the power arc
Assembly of the power
arc is carried out in a
horizontal plane similar to
the assembly of the end
wall.
End section assembly.
Assembly is carried out
according to the
fig.4.1.
The assembled power arc
is brought to the end wall
with the installed runners,
is raised to the height
of the end runners and
joined with their upper
ends. It is recommended
to connect the outermost
and middle runners first.
For the initial fixation
of the power arc on the
runners, participation of
three people is required
for holding of the frame.
2кн
2к
2кн
INSTALLATION SEQUENCE
INSTALLATION SEQUENCE
