KSLi arrays and assembly procedures
7. Raise the back of the cabinet until the Rear link of the adapter
fits into the rear rigging strand of the cabinet.
8. Align the inner hole of the Rear link with the
[0°] hole of the
cabinet's rear rigging strand.
9. Insert the first Locking pin
[1] to fix the Rear link and cabinet in
place.
10. Insert the second Locking pin (Safety pin
[S]).
11. Remove the T-handles.
7. Add further TOP cabinets
1. Prepare the Front and Splay links of the next cabinet as
described in
Chapter 2.5.1 "Front link mechanism"
Chapter 2.5.2 "Splay/Rear link
2. Attach the T-handles.
3. Lift the assembly to a suitable working height.
4. Release and pull out the fixing bolt at the bottom of the front
rigging strands of the first/upper cabinet.
5. With the front grill facing upwards, attach the prepared next
cabinet to the corresponding slots at the front of the upper
cabinet.
6. Insert and handtighten the fixing bolts of the upper cabinet's
Front links on both sides.
7. Raise the bottom cabinet until the Splay link of the upper
cabinet fits into the rear rigging strand of the bottom cabinet.
8. Align the inner hole of the Splay link with the appropriate hole
for the desired splay angle (e.g.
[2°]).
9. Insert the first Locking pin
[1] to set the angle and fix the
cabinet in place.
10. Insert the second Locking pin (Safety pin
[S]).
11. Remove the T-handles.
To add further cabinets, proceed in the same manner until the
assembly is completed.
d&b KSLi Rigging manual 1.1 en
26
