SL-Series rigging components
Pos.
Component
Description
[1a]
Z5701
GSL Flying frame
The SL-Series flying frames
[1a]/[1b] are constructed from high-grade steel following the
principles of truss construction to achieve the lowest possible dead weight.
They are designed to support arrays (columns) consisting of either:
Z5701 GSL Flying frame:
Þ
Z0750/Z0751 GSL8/GSL12 cabinets, or...
Þ
Z0760 SL-SUB cabinets.
Z5722 KSL Flying frame:
Þ
Z0780/Z0781 KSL8/KSL12 cabinets, or...
Z0785 KSL-SUB cabinets.
[1b]
Z5722
KSL Flying frame
[*1c]
Parking slot for
Z5723 KSL Load beam
In connection with the KSL Touring cart, the KSL Load beam is stored on top of the KSL
Flying frame (refer to
Chapter 3.16.1.4 "Loading the carts"
[2]
At the center front and rear of the frames, dedicated pickpoints
[2] and corresponding
Locking pins (Type A: 16 x 55 mm) are provided to accept the corresponding load beam.
[*3]
Rear link (Frame)
The rear links of the frames are used to attach the first TOP cabinet to the frame.
To attach the frame to SUB cabinets, the Rear link of the frame can be moved to the
respective SUB position of the Load beam using the enclosed Rear link adapter
[*7] (refer
to
Chapter 8.2 "Rear link of the Flying frames" on page 58).
[4]
Z5705
Safety chain 4 t
The Z5705 Safety chain is supplied with the corresponding GSL or KSL Flying frame set.
[5]
Safety point(s)
The flying frames are fitted with two safety points, each equipped with a 4.75 t shackle to
attach a secondary safety device using the enclosed Safety chain (refer to
"Secondary safety" on page 31).
[*6]
etherCON connector socket
In connection with the d&b Z5711 ArraySight sender unit, the etherCON connector socket
acts as a feed through to allow for easy connection of the sender unit.
[*7]
Rear link adapter
To attach the frame to SUB cabinets, the Rear link of the frame can be moved to the
respective SUB position of the Load beam using the enclosed Rear link adapter, which
provides the necessary extension length (refer to
Chapter 8.2 "Rear link of the Flying
[*8a/8b] Z5711
ArraySight sender unit
By factory default, the flying frames are equipped with a calibrated and adjusted d&b
Z5711 ArraySight sender unit
[8a] (laser inclinometer). An appropriate, shielded CAT5e
1:1 cable, 30 m (100 ft) is also provided (K6006.200.00 -
[8b]) to allow either read out
via the d&b Z5712 ArraySight meter unit (single operation) or via R1 in connection with the
d&b Remote control network (remote operation - OCA/AES70).
For detailed information on the d&b ArraySight inclinometer system, please refer to the
ArraySight manual which is also supplied with the flying frames.
[9]
Four dedicated holes are provided at the front of the frame.
The center hole serves as the exit for the laser beam, while the three surrounding holes allow
for the adjustment of the ArraySight sender unit
[8a], if necessary.
Instruction labels providing vital safety and rigging instructions.
d&b SL-Series Rigging manual 1.10 en
15
