SL-Series rigging components
Manually loading for Tension mode
The following procedure describes the loading for GSL cabinets.
For KSL cabinets proceed in the same manner.
1. At the front of the cart, release the Locking pins on both sides.
2. At the rear center Splay link slot, release the bottom Locking
pin.
3. Attach the first cabinet to the front support and reinsert the
Locking pins on both sides.
4. At the rear of the cabinet, release Locking pin
[3] and fold out
the Splay link.
5. Reinsert Locking pin
[3] to the Tension mode hole at the
bottom of the rigging strand (
Þ
).
6. Insert the Splay link into the Splay link slot.
7. Lift the back of the cabinet until the Splay link has engaged
and reinsert the bottom Locking pin to fix the link in place.
8. Finally, extend the Front links of the first cabinet to attach the
next cabinet.
9. Attach the next cabinet to the previously extended Front links
of the first cabinet and reinsert its Locking pins on both sides.
10. At the rear, store the Splay link in its Park position (
Þ
)
using Locking pin
[3].
11. Locking pins
[1] and [2] can remain in their hole positions.
12. For the remaining two cabinets, proceed in the same manner
as for the second cabinet.
13. On the last cabinet, ensure the Front links are stored in their
Park positions.
d&b SL-Series Rigging manual 1.10 en
37
