Tension mode setup
Provided...
▪ The touring cart is loaded and prepared for Tension mode as
"Manually loading for Tension mode"
on page 37) and in position.
▪ The load beam has already been attached to the flying frame,
as described in the previous section
beam to the flying frame" on page 45.
▪ The safety chain has already been attached to the flying frame,
as described in
Chapter 3.14 "Secondary safety"
... proceed as follows:
1. Preparing the first assembly
1. For the upper three cabinets, release Locking pin
[3] and fold
out the Splay link.
2. Reinsert Locking pin
[3] to the lowest hole position of the
bottom hole grid to fix the Splay link in its Tension mode
position (
Þ
).
3. On every cabinet, release Locking pin
[2].
4. On the top hole index, preset the splay angles according to
your ArrayCalc project using Locking pin
[1] (See also
Chapter 2 "SL-Series rigging modes - 2 in 1"
Þ
5. Lift the assembly including the cart until all Splay links have
engaged.
6. Reinsert Locking pin
[2] (Safety pin) on all cabinets.
7 Tension mode setup
d&b SL-Series Rigging manual 1.10 en
54
