d&b audiotechnik Z Series, Mounting Instructions

1.3. Intended use
The d&b Z5404/05/06 Flying bracket 8S/10S/12S must only be

used in conjunction with the d&b xS-Series loudspeakers 8S, 10S/

10S-D and 12S/12S-D as described in these mounting instructions.

The bracket can be:
▪ directly mounted to ceilings.
▪ vertically flown and mounted to bars and truss with a tube

diameter of up to 70 mm (2.75") using the Z5010 TV spigot

and the Z5012 Pipe clamp.

Note: Refer to the specific mounting instructions for assembly

and operation of these accessories.

1.4. Mounting options and angle settings
Mounting holes are provided on the tie bar of the bracket.

Two 6.5 mm (0.25") holes are provided onn the tie bar for fixing

the bracket directly the ceiling.

Two M8 threaded inserts at the d&b standard spacing of 115 mm

(4.5") are provided to allow the attachment of the Z5010 TV

spigot.

Vertical angles can continuously be set in the range of 90°.

1.5. Assembly

Fixing the bracket to the ceiling

NOTICE!

Only use mounting parts (fixing anchors and screws) that are

suitable for the intended application.
Observe the occurring extraction forces acting on the fixing

anchors and screws. The rated extraction forces for the respective

cabinet are listed in the following table.

Application

Rated extraction forces

8S

10S

12S

Ceiling mounting

100 N

250 N

300 N

To attach the bracket to the ceiling, use the holes shown in the

graphic opposite to provide adequate support.

A corresponding fixing template is supplied with these mounting

instructions. Refer to 

Þ

 Chapter 2. "Fixing templates"

on page 7.

Fig. 2: Z5404/05/06 Rigging examples

Fig. 3: Z5404/05/06 Mounting holes

d&b Z5404/05/06 Mounting instructions 1.1 en

5