1.6 High stand assemblies
In conjunction with the d&b Z5024 Loudspeaker stand adapter, V-
Point/Vi-Point cabinets can be mounted onto a loudspeaker stand
or stand adapter such as the d&b Z5009, Z5013 or Z5550 with a
tube diameter of 35 mm (1.4").
Operational safety
CAUTION!
Potential risk of personal injury and/or
damage to the components.
Due to the size and weight of approx. 40 kg (88 lb) of the entire
assembly (cabinet/bracket), we strongly recommend you to
observe the following assembly procedure, to avoid any personal
injury and/or damage to the components.
▪ The assembly should always be carried out by two persons.
▪ During assembly pay attention to the possible risk of crushing or
jamming fingers. Wear suitable protective clothing such as
protective gloves.
Assembly procedure
1. Attach the bracket to the cabinet as described in the previous
2. Attach the Z5024 adapter as shown in the graphic opposite
(1/2).
3. With one person on each side, lift the cabinet assembly as
shown in the graphic opposite (3).
4. Attache the cabinet assembly to the pole of the respective high
stand or stand adapter and directly align the cabinet to the
desired vertical angle as shown in the graphic opposite (4).
5. Finally tighten all handbolts.
To dismantle the assembly, proceed in the same manner and in
reverse order.
Z5383 High stand assemblies:
Z5383 with Z5009 Loudspeaker stand with winder.
Z5383 with Z5013 Loudspeaker stand with winder M20.
Z5383 with Z5550 M20 Stand adapter.
d&b Z5383 Mounting instructions 1.4 en
6
