Joining the cabinets
1. Lift the first (upper) cabinet to a suitable working height.
2. On the second (bottom) cabinet, attach the link to the
corresponding hole pair (i.e. 8/9).
3. Fix the link in place with two Locking pins.
4. Lower the upper cabinet until the corresponding hole of the
second flying adapter (hole 8) is in line with the link.
5. Insert one locking pin.
6. Slightly lift the entire assembly.
7. Raise the bottom cabinet until the second hole (hole 9) is in
line with the link and insert the second Locking pin.
8. Recheck your work before lifting the assembly to its operating
position.
↳Ensure all four Locking pins are fully inserted and properly
locked
Joining the cabinets
Shown: Hole pair 8/9, vertical splay of 5°
d&b Z5384/Z5551 Mounting instructions 1.4 en
8
