2.3 Z5384 Assembly
1. Attach the adapter
[1] to the top panel of the cabinet as
shown in the graphic opposite.
2. Fix the adapter using the three hand bolts
[2].
↳Ensure the hand bolts are properly tightened before lifting
any load.
2.4 Z5384 Adjustments
Vertical aiming
The adapter provides 14 locating holes (12.5 mm) to allow a
single cabinet to be set to specified vertical angles as listed in the
table below. The vertical angle is related to the center of gravity of
the cabinet.
Hole grid
1
2
3
4
5
6
7
8
9
10
11
12
13
14
Angle (°)*
VP/ViP
+17
+13
+8.5
+4.5
0
–4.5
–8.5
–13
–17
–21
–25
–29
–33
–36
Angle (°)*
24S/24S-D
+18
+14.5 +10.5 +6.5
+2.5
–1.5
–5.5
–9.5
–13
–17
–21
–25
–28.5
–32
*Positive value: Cabinet points upwards. Negative value: Cabinet points downwards.
Horizontal aiming
The horizontal aiming is adjusted at the suspension point.
Assembly*
*Shown: V-Point cabinet. The same assembly procedure applies to Vi-Point and
24S/24S-D cabinets.
d&b Z5384/Z5551 Mounting instructions 1.4 en
6
