WARNING!
Potential risk of personal injury and/or
damage to material!
Always secure ground stacked setups against movement and
possible tipping over.
Observe the maximum number of cabinets permitted. This is
particularly important when setting up mixed ground stacks.
2.1 Preparing the setup
General
Check the acoustical and mechanical setup using ArrayCalc and
prepare enough printouts for each array.
When on site first:
▪ Clear the working areas and ensure there is enough space to
set up the ground stack.
▪ Prepare the cables and link cables according to the number of
amplifier channels and cabinets used.
Inspections before setup
Before setting up the array, carry out a visual inspection of all
system components for faults. This also includes the loudspeakers
and in particular the rigging parts of the cabinets (Front and
Splay/Rear links).
Damaged components must be withdrawn from use immediately.
Please follow the instructions given in
2.2 Order of assembly
2.2.1 Y8/Y12 Ground stack
1. Attach the first cabinet to the Base plate
1. Place the Base plate on the ground.
2. Place the first cabinet onto the Base plate until the cabinet's
slots fit into the corresponding fixtures on the Base plate.
3. Insert and lock the Locking pins of the Base plate on both
sides.
2 Assembly
d&b Z5396 Rigging manual 1.1 en
5
