d&b audiotechnik Z5398, Mounting Instructions

1.3  Intended use
The d&b Z5398 YP Horizontal bracket must only be used in

conjunction with d&b YP or YiP cabinets (Y7P/Yi7P or Y10P/

Yi10P) as described in these mounting instructions.

The bracket can be:
▪ horizontly or verticaly mounted to walls.

▪ directly mounted to ceilings.

▪ horizontally flown from overhead bars or trusses with a tube

diameter bewtween 40 mm to 70 mm (1.5" to 2.75") using the

Z5010 TV spigot with fixing plate in conjunction with the

Z5012 Pipe clamp.

▪ mounted in conjunction with the Z5552 Bracket connector with

a second horizontal bracket to set up an vertical array of two

cabinets.

Note: For assembly and operation of these accessories, refer

to the specific mounting instructions.

1.4  Mounting options and angle settings
Mounting holes are provided on the tie bar of the bracket:

Mounting type

Position

Horizontal wall mounting

[a] + [b]

Vertical wall mounting

[a]

Ceiling mounting

[a]

TV spigot (Z5010) mounting

[b]

Five mounting holes are provided at each end of the tie bar to

attach the Z5044 MAX Bracket connector, the Z5053 Ci60/Ci90

Bracket connector or the Z5054 Ci60/Ci90 Flying adapter. For

more information, see the respective manual.

One 11 mm (0.43“) hole 

[c] and two semi-circular slots [d], [e]

are located at each end of the bracket serving as fixing points for

angle settings.
Using the M10 threaded inserts at the top and bottom of the

loudspeaker cabinet, the bracket can be attached in two directions

to allow angle settings over a range of 105°, starting from +15°

through to –90°. The following mounting options and angles

settings are possible.

Option 1
The bracket is attached to the cabinet with hole 

[c] facing to the

front of the cabinet. Both bolts are fitted into slot 

[d].

The vertical coverage angle can be set over a range of 30°,

starting from 0° to –30°.

Z5398 Mounting holes

d&b Z5398 Mounting instructions 1.3 en

5