1.4 Assembly
Tools required:
▪ Philips screwdriver #PH2.
To attach the base plate to the stand adapter, proceed as follows:
1. Place the stand adapter on the ground.
2. Attach the base plate onto the stand adapter, using the plastic
washers
[3] and screws M6 x 16 [2], as shown in the
graphic opposite.
Attach the cabinet to the base plate
1. Place the first cabinet onto the base plate until the cabinet's
slots fit into the corresponding fixtures of the base plate.
2. Slightly lower the cabinet until the cabinet's slots have
engaged into the corresponding fixtures of the base plate.
3. At the rear, release the Locking pin of the Splay link.
4. Fold out and remove the Splay link of the cabinet.
↳The tilt angle of the cabinet can be applied using the Splay
link of the Base plate.
For these purposes, please refer to the Z5458 Rigging
manual.
Attaching the base plate to the stand adapter
d&b Z5460 Mounting instructions 1.1 en
5
