1.4 Mounting options and angle settings
One 9 mm (0.35") hole is provided at each end of the tie bar to
attach the bracket directly to the ceiling.
Each end of the bracket is equipped with a semi-circular slot to
allow the subwoofer to be vertically aligned within a range of 60°
(
±
30).
1.5 Assembly
Attaching the bracket to ceilings
NOTICE!
Only use mounting parts (fixing anchors and screws) that are
suitable for the intended application.
Observe the occurring extraction forces acting on the fixing
anchors and screws. The rated extraction force is
620 N.
To attach the bracket to the ceiling, use the holes shown in the
graphic opposite to provide adequate support.
A corresponding fixing template is supplied with these mounting
instructions. Refer to
Chapter 2 "Z5557 Fixing template"
Preparing the cabinet
The threaded inserts of the cabinet are covered by dummy caps in
cabinet color. To remove the caps, proceed as follows:
1. Cut out the caps along the recessed spline using an
appropriate cutting knife.
2. Carefully take off the caps and ensure the cabinet coating is
not peeled off.
Z5557 Mounting holes
d&b Z5557 Mounting instructions 1.2 en
5
