d&b audiotechnik Z5600.552, Manual

5.1  Overview

Rear panel connectors

Front panel connectors, controls and indicators

[1]

powerCON TRUE 1 TOP

®

 mains connector socket.

Refer to 

Þ

 Chapter 5.2 "Mains connection" on page 13.

[2]

Ethernet switch with 8 x RJ45 ports.

Refer to 

Þ

 Chapter 5.4 "Rear panel" on page 15.

[3]

etherCON

®

 switch ports ETH 9 - ETH 11.

Refer to 

Þ

 Chapter 5.3.1 "ETH 9 - ETH 11" on page 13.

[4]

Mode button.

Refer to 

Þ

 Chapter 5.3.2 "Mode selection" on page 14.

[5]

Multi-colored LED indicators.

Refer to 

Þ

 Chapter 5.3.3 "LED indicators" on page 14.

5.2  Mains connection

WARNING!
Potential risk of electric shock.

The device is a protective class 1 unit. A missing earth (ground)

contact may cause dangerous voltages in the housing and controls

and may lead to electric shock.
▪ Connect the unit to mains power supplies with protective earth

only.

▪ If there is any sign of obvious damage to the power cord

and/or mains connector, do not use the power cord and

replace it before further use.

▪ Please ensure the mains connector is accessible at any time to

disconnect the unit in case of malfunction or danger.

Before connecting the device to mains voltage, check that the

mains voltage and frequency correspond to the specifications on

the rating label above the mains connector socket on the rear

panel of the unit.
A mains connector socket 

[1] is fitted on the rear panel and an

appropriate power cord 

[1.1] is supplied.

5.3  Front panel

5.3.1  ETH 9 - ETH 11

The DN1 device provides an 11-port Ethernet switch for different

network topologies, redundancy (max. two devices) and advanced

functionality with AVB. Three connectors are provided on the front

panel.

Power over Ethernet
The « ETH 10/PoE» and «ETH 11/PoE» Ethernet connectors also

provide Power over Ethernet based on IEEE standard 802.3af.

Each port delivers a maximum of 15.4 W, both ports deliver a

maximum total of 25 W. If the maximum power is exceeded, PoE

supply will be shut off.

Note: Either of the « ETH 10/PoE» or «ETH 11/PoE» connector is also intended to
feed an inclinometer such as the d&b ArraySight sender unit, which is integrated in
the flying frame for vertical aiming of the entire array.

5  DN1 Ethernet switch

d&b Z5600.552 Manual 1.2 en

13