d&b audiotechnik Z5601.002, Manual

6.3.2  Mode selection

The DN1 device features a «MODE» button on the front panel.
This button is used for three different purposes:
▪

Configuration mode

Toggle between primary and secondary configurations.

▪

Reset mode

Reset the device to remote settings default.

▪

Wink mode (device indentification)

Visual identification of your device.

Configuration mode
If the DN1 device is operated within an AVB network, you must

configure all switches for use in a primary or secondary network.

The DN1 recognizes a primary or secondary connection of the

connected AVB device and indicates an error if a primary port has

been connected to a secondary switch and vice versa.
To enter the Configuration mode, proceed as follows:
1. Select and hold the «MODE» button for two seconds.

↳Either the «PRI» or the «SEC» LED starts to flash in periods

of one second with an uptime of 50%.

2. Select the «MODE» button to toggle between primary and

secondary configurations.

↳After five seconds of inactivity, the «PRI» and «SEC» LEDs

leave the Configuration mode and switch back to normal

display mode.

Note: Without an DHCP server in LinkLocal IP mode:
▪ IP adress range in primary mode: 

169.254.xxx

▪ IP adress range in secondary mode: 

172.31.xxx

Reset mode
The remote reset function resets all settings related to remote

communication to factory defaults. To reset the DN1 device to

defaults, proceed as follows:
1. Select and hold the «MODE» button for five seconds.

↳All AVB port status LEDs turn red for two seconds.

All other LEDs are off.

2. Release the «MODE» button.
3. Within two seconds, select the «MODE» button once again.

↳All AVB port status LEDs turn red for two seconds.

All other LEDs are off.
Alle remote settings are set to default.

Wink mode (device identification)
To activate the Wink mode, proceed as follows:
1. Select the «MODE» button once.

↳All AVB port status LEDs flash in the color of the current

Configuration mode (  = Primary /   = Secondary).

2. After three seconds, the Wink mode stops automatically.

6.3.3  LED indicators

All device states and operating modes are indicated by dedicated

multi-colored LEDs.

Note: In case of an device error, connect the device to R1 via

OCA to obtain further information.

d&b Z5601.002 Manual 1.2 en

15