d&b audiotechnik Z5601.002, Manual

3.1  Intended use

Z5606.000 Front panel

The Z5606.000 Mains power distributor is designed and

dimensioned to provide and distribute the mains power supply

necessary for 

six D40 amplifiers.

It is a protective class 1 unit with IP class 20 (NOT rain-, drip-, or

splash-proof!).
The Z5606.000 Mains power distributor must not be used for any

other purpose or outside of a system rack.

3.2  MAINS IN

WARNING!
Potential risk of electric shock.

The mains power distributor is a protective class 1 unit. A missing

earth (ground) contact may cause dangerous voltages in the

housing and controls and may lead to electric shock.
▪ Connect the unit to mains power supplies with protective earth

only.

▪ If there is any sign of obvious damage to the power cord

and/or CEE mains connector, do not use the unit and replace it

before further use.

▪ Do not connect or disconnect the CEE mains connector under

load or live.

▪ Please ensure the mains connector is accessible at any time to

disconnect the unit in case of malfunction or danger.

Apart from the six fixed single-phase mains power lines (6 x

MAINS TO AMPS 230 V) for the internal mains power supply of

the amplifiers, the Z5606.000 Mains power distributor is supplied

with a fixed 3-phase power cord equipped with a 32 A CEE

(Cekon) mains connector.
Required mains supply network configuration

3-phase 230/400 VAC - 50/60 Hz - 32 A

max.

 B or C-Frame type

(3PNPE).
Connect only 

one rack assembly to the mains power outlet of the

onsite sub-distribution.
Each single-phase mains power line is equipped with a dedicated

circuit-breaker (16 A / B-Frame type).
The respective circuit-breakers of the onsite mains distribution are

still necessary for this purpose.

Z5606.000 Rear panel

3  Z5606.000 Mains power distributor 32 A CEE

d&b Z5601.002 Manual 1.2 en

9