23
There are following variants for the connection of the locomotive function decoder
FH18A:
4
In case your locomotive is equipped with an interface according to NEM 651, you need for FH18A the connecting
adapter
N18-K-1
. It has already the appropriate connections for this plug. Short the ribbon cable up to approxi-
mately 5 mm and remove the rest of the insulation. The decoder can be inserted into the interface without any
problem now.
5
In case your locomotive is equipped with an interface according to NEM 652, you need for FH18A the connecting
adapter
N18-G-2
. It has already the appropriate connection cables for this socket with an 8-pin plug. The decoder
can be inserted into the interface without any problem now.
6
In case your locomotive is equipped with an 18-pin interface (Next18), you can plug FH18A directly into the inter-
face without any problem.
7
In case your locomotive has no interface socket, you need for FH18A either connecting adapter
N18-K-3
(without
SUSI) or
N18-G-3
(with SUSI) for an idividual wiring.
8
Connecting adapter
N18-K-0
(without SUSI) or
N18-G-0
(with SUSI) should be used only by experienced model
railroaders, as the connection wires must be soldered directly onto the respective adapter.
There are following variants to connect the locomotive function decoder
FH22A
:
9
In case your locomotive is equipped with a 22-pin interface (PluX22), use decoder FH22A-
4
. It has already the
appropriate plug for this socket. The decoder can be inserted into the interface without any problem now.
10 In case your locomotive has no interface socket, use decoder FH22A-4 together with the adapter P22-
3
for
individual wiring.
11 Decoder FH22A-
4
together with the adapter P22-
0
should be used only by experienced model railroaders, as the
connection wires must be soldered directly onto the adapter.
Summary of Contents for DH05C
Page 68: ...68 Blank page for your notes...
