11
Encapsulating with a SuperStick® Flexible Pouch using a SuperStick® Sled or release
board:
1.
Refer to the instruction sheet packed with each box of SuperStick® Flexible pouches for specific
instructions on encapsulating.
2.
Also, refer to the instruction sheet for information on Compatible Media, Process Conditions, and
Technical Information.
3.
The Flexible Pouch consists of two pieces of film that are hinged at one end, along a short side.
Separate the two pieces starting at the end opposite the hinge. Take care not to break the hinged
seal.
4.
Insert the article to be laminated in the pouch so there is at least a 1/8” (3mm) border around each of
the sides. This ensures that moisture never reaches the image.
5.
Place the pouch with the image on the release carrier board included with the flexible pouches or
SuperStick® sled carrier. The SuperStick® sled is carrier board to assist in the handling of large Flexible
Pouches. It is made of materials that will not damage or cause excessive wear to the EXP 42” Pouch
Laminator). Smooth out any wrinkles with the side of the hand or a soft, flexible squeegee.
6.
Better results may be achieved by taping the leading edge of the pouch to the sled using masking
tape.
7.
Adjust the Control Knob to the 3/16” setting for the SuperStick® Sled or 1/16” for the release carrier
board to accommodate its thickness. Be sure that the heat is on, the middle LED indicator is on and
the bottom LED is constantly on.
8.
Slowly insert the sled or release carrier board with the Flexible Pouch on top into the inlet opening.
Ensure that the sled or release board is centered and straight. A gentle push may be required to start
the sled or release board into the machine. Hold the edge of the sled or release board until it is
engaged and the laminator begins pulling it on its own.
9.
The sled or release board will feed through the laminator and automatically exit at the rear of the
machine.
10.
THE SLED or RELEASE BOARD WILL BE HOT!
Allow it to lie flat and cool before removing the tape.
11.
If there is any dirt or adhesive on the surface of the board, it can be removed by dampening a lint free
cloth with ISO Propyl Alcohol (IPA) and wiping the surface.
