Part NO: 212-0024-8S
4 September 24th, 2020
Wiring and Setup Instructions
1. Good wiring practice and thorough knowledge of vehicle power system is required by the
installer of this and any other product.
2. Looms, grommet, cable ties or other installation hardware should be used to anchor and
protect wires
3. All wire should conform to the minimum wire size as specified by the manufacturer.
4. Splices should be minimized and made in a fashion so as to protect from corrosion to re-
duce loss of conductivity.
Warning
Installation and Mounting
1. Any device used inside a vehicle, may cause severe personal injury if not properly mounted
and secured. Objects used in the vehicle may become airborne during a collision or other
sudden changes in vehicle speed or direction, such as braking, acceleration or turns.
2. Be sure to mount unit through the steel of the vehicle. Avoid mounting through plastic or
other non-structural materials.
3.
POINT OF INSTALLATION MUST NOT INTERFERE WITH DEPLOYMENT OF
VEHICLE AIR BAGS.
4.
D&R Electronics recommends this and any of our other products be installed by quali-
fied professionals
.
Warning
Mounting the PDU unit
The
PDU-8S
may be mounted anywhere inside the vehicle away from heat, moisture or the ele-
ments.
NOTE the PDU is not watertight
do not mount it in the engine compartment, on the ex-
terior of the vehicle or an area where moisture/dirt/ other contaminants can fall into the ex-
posed areas of the PDU.
Ensure that the mounting location is flat and the device is secured to solid vehicle body parts
To mount the
PDU
unit proceed as follows:
1. Determine an appropriate mounting location
2. Confirm there is adequate access and clearance for the wiring and its connections.
3. Secure the
PDU
with 4 self tapping mounting screws (not supplied).
