Part NO: 212-0024WB
3
July 30th, 2019
General Warning
1. The use of emergency warning devices does not ensure the safety of the operator. The
operator is responsible to ensure safe operation of the vehicle regardless of whether
the warning device is in operation or not
2. The effectiveness of this or any warning device is highly dependent on proper installa-
tion and maintenance.
Read the manufactures instructions before installing and follow
all recommendations.
3. When in use the operator must ensure that the warning signal is visible and not ob-
structed by vehicle components (i.e. open trunk lid), people or other obstructions
4. This device is intended for use by authorized personnel only The user is responsibility
to ensure that all local, state/provincial and federal laws are being complied with.
D&R assumes no liability for any loss resulting from the use of this device.
5. The device must be installed so as not to reduce the output performance of vehicle sys-
tems
6. Placement of control switches must be so as to provide convenient reach for the opera-
tor without loosing eye contact with the road.
7. Emergency warning devices require high electrical voltages and/or currents. Properly
connect and ground all circuits. Shorting or improper grounding of this device may
caused personal injuring, vehicle damage or both
8. All operators should be properly trained in the operation of this device to ensure
both their and public safety
Unpacking & Pre-Installation Check
D&R Electronics Co. advises that you open and examine all shipments within
48 hours of
receipt
. The
Power Distribution Unit PDU
is shipped pre-assembled and factory tested.
All necessary hardware for standard installation is included. Remove all components from
the shipping carton.
Use this pre-installation check list to verify your unit:
1. Confirm contents with the packing slip
2. Examine unit for damaged in transit (i.e. scratches, broken or bent connectors. etc).
Report any damage to the carrier immediately. Keep all shipping material
3. The unit is factory tested and a pre-installation check is not needed.
