A
·
X
·
U
·
M User Manual
Version 2.5 - 2011-01-28
AXUM from D&R - Phone: +31 294 418014 - E-Mail:
info@d-r.nl
- 12 -
4.4.2.1
Sources
Each module can receive audio from the matrix using so called ‘sources’. A source is given a name,
left/right physical input and some additional settings (think of phantom, pad, redlight settings). For
example if we make source ‘MIC1’ with phantom on we can route this to module 1 and/or module 13.
So the MIC 1 is used at console 1 but also at console 2 (or 3).
4.4.2.2
Destinations
Audio is sent to physical outputs by so called ‘destinations’. A destinations given a name, left/right
physical outputs and some additional settings (default audio-source, N-1 etc). For examples we make
destinations ‘Line out 1’ and ‘Dig out 1’ which both get the audio from ‘Prog A’.
4.4.2.3
Console/Surface functionality
After the consoles are set-up/configured and the inputs and outputs are set-up with the correct
settings of sources/destinations you can start using the console functionality. Which functionality is
available depends on the configuration of the system.
It is important to make the required ‘real-time’ functionality available via the surface and rack
configuration menu’s. Actually here you define the ‘knob functions’.
4.4.2.4
Console startup/Presets
At the console start up it will load the last backup or the programmed defaults, this depends on a
setting in global configuration.
The programmed defaults are:
-
The information set within the webbrowser pages
-
For the modules ‘module preset 1A’ is selected by default.
Further in live use of the console(s) you can make use of presets:
-
Processing presets
-
Module presets
-
Console presets
processing preset:
A processing preset contains module-settings (think of EQ, Dynamics etc. etc).
When a source is selected by the control surface encoder, the assigned default processing preset is
loaded.
Module preset:
The module preset 1A t/m 4B defines a combination of: Source, Processing preset and Routing
preset.
In this case if module preset 1B is recalled:
-
The configured ‘preset 1B source’ is set on the module
-
The corresponding processing preset is set on the module. Processing preset field that not
override the module will set according to the module configuration settings (if ‘Use at source
select’ is active).
-
The routing as given by ‘module preset 1B’ is restored.
Console preset:
The console preset consists of two main parameters:
-
It loads Module preset 1A, 1B, 2A, 2B, 3A, 3B, 4A or 4B.
-
It loads a buss/monitor buss preset.
Here also you can define if a separate buss is used within the preset (the configuration setting ‘Use’ –
Yes/No).
In general you can say:
-
The console will startup in the defaults like given in the webpage.
