W E B S T A T I O N M a n u a l P a g e 31
13.1.5
Settings
Pressing the gear wheel symbol at the right upper corner will open the (communication) settings window.
Webstation Meters communicates indirectly with the console via a UDP/IP (User Datagram Protocol) connection. Since the only
available communication interface on the webstation console is USB, another Webstation Control application is required to run
on the PC the Webstation is connected to. The Webstation Control acts as a USB/UDP gateway and provides a communication
interface for client applications anywhere on the network, like Webstation Meters.
13.1.6
Online indicator
Below the D&R logo the online indicator is located. This indicator will become green (online) when receiving metering data.
Make sure the Webstation Control application is running on the main PC in order to provide the metering data to Webstation
Meters.
When the indicator shows an offline status (grey) the Webstation Control application is not running or the Webstation console is
disconnected.
13.1.7
Console signals
At the right side Webstation Meters contains a set of console signals indicating internal states of the console.
PHONE
: Informs you about an incoming call on module 6 (VoIP).
ON AIR 1/2
: Configurable Logical busses. Can be attached to a GPO for example.
NONSTOP
: Used as indicator as well as a remote nonstop switch by clicking on the signal.
SILENCE
: Indicates the silence detector is in alarm state. In this alarm state NONSTOP is flashing to indicate the console
has switched automatically to nonstop mode. The alarm can be reset by clicking on NONSTOP or by pressing
the nonstop switch on the console.
MIC ON
: One of the mic modules is active. Behaves parallel to the hardware MIC ON output.
CRM MUTE
: CRM buss is muted by active mic module where crm-mute option is enabled.
13.1.8
Module states
The Webstation console contains six modules in which their current state is represented by the rectangular icons at the bottom
of the application. Each icon shows the state of the ON switch and the selected source of the relevant module.