Dane Technologies, Inc.
QuicKART 2000
Owner’s Manual
7105 Northland Terrace, Minneapolis, MN 55428 / 888-544-7779 / 763-544-7779 / Fax 763-544-4234
www.danetechnologies.com
970-026 rev 3-1-06
QuicKART 2000
Owner’s Manual
Operating Instructions
Training Guide
Table of Contents
Topic
Section
Owner’s Manual and Operating Instructions......................... 1
Troubleshooting Flowchart ................................................... 2
Training Manual .................................................................... 3
Certified Operator’s Test ....................................................... 4
Note on radio equipment used:
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) This device must accept any interference
received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
−
Reorient or relocate the receiving antenna.
−
Increase the separation between the equipment and receiver.
−
Connect the equipment into an outlet on a circuit different from that which the receiver is
connected.
−
Consult the dealer or an experienced radio/TV technician for help.
The abbreviation IC, before the Canadian Registration Number signifies that registration was performed
based on a Declaration of Conformity indicating that Industry Canada technical specifications were met. It
does not imply that Industry Canada approved the equipment.
The CE mark, if present, declares that this equipment meets relevant EU Directives and Standards.
To Order Parts Call 1-888-702-5326 - https://monsterfloorequipmentparts.com