Instruction
No:
177R0091
V0
Jan
2009
Page
4
Figure 7. Front cover of cable channel.
7. Route the USB cable along the
same route as the LCP cable.
This is shown by the dotted red
line in Figure 8. Utilize cable ties
to secure the USB cable to the
LCP cable until the cable is inside
the cable channel.
Figure 8. Routing of USB cable in rectifier cabinet.
8. Route the USB cable from the
cable channel to the control card
as shown in Figure 9.
Figure 9. USB cable.
6. Remove the cable-channel cover
from the front of the cable chan-
nel to enable insertion of the USB
cable. See Figure 7.