1.5.6 Installing Gaskets to the Back of a
D7h/D8h Enclosures
NOTICE
APPLYING GASKETS
This kit contains gaskets to ensure a proper seal between
metal parts. Before adhering a gasket to a part, check that
the part matches the gasket and that no holes are covered.
Remove paper backing and place the sticky side on the part.
1.
Install 1 of the vent gaskets (2) around the exhaust
vent opening on the back of the enclosure.
2.
On top of the gasket, install the exhaust spacer (1) to
the back of the enclosure panel using 8 M5x18
screws. Torque to 5.1 Nm (45 in-lb).
3.
Install 1 of the vent gaskets (2) to the exhaust spacer.
4.
Apply the 2 labels (3) over the back-channel form
holes.
5.
Install 1 of the vent gaskets (5) around the intake
vent opening on the back of the enclosure.
6.
On top of the gasket, install the intake spacer (4) to
the back of the enclosure panel using 8 M5x18
screws. Torque to 5.1 Nm (45 in-lb).
7.
Install 1 of the vent gaskets (5) to the intake spacer.
8.
Install the slot gasket (6) to cover the mounting holes
used to secure the enclosure to the base plate.
1
Exhaust spacer
2
Exhaust vent gaskets
3
Slot gasket
4
Intake spacer
5
Intake vent gaskets
6
Slot gasket
Illustration 1.13 Installing Sealing Gaskets to Back Panel for the
D7h/D8h Frequency Converters
Installation Instructions
In-back/Out-back Cooling Kit for D5h/D6h and D7h/D8h Enclosures VLT® Series FC 102, FC 202,
and FC 302
8
Danfoss A/S © 10/2016 All rights reserved.
MI70F102
