[125] Follower
Marker
NOTICE
This option is available only with
software version 48.XX.
Normally open contact. Serves as input for
follower marker signal during marker
synchronization based on the option selected
in
parameter 3-33 Sync. Mode & Start Behavior
.
[126] Follow
Marker Inv
NOTICE
This option is available only with
software version 48.XX.
Normally closed contact. Serves as input for
follower marker signal during marker
synchronization based on the option selected
in
parameter 3-33 Sync. Mode & Start Behavior
.
[231] Power
Limit Mot.
Serves as input to activate the power limit
function in the motor mode. See
parameter
group 4-8* Power Limit
.
[232] Power
Limit Gen.
Serves as input to activate the power limit
function in the generating mode. See
parameter group 4-8* Power Limit
.
[233] Power
Limit Both
Serves as input to activate the power limit
function in both the motor and the
generating mode. See
parameter group 4-8*
Power Limit
.
[234] Light Load
+
Evacuation
Use this option to activate both light load
detection and evacuation.
5-12 Terminal 27 Digital Input
Functions are described in
parameter group 5-1* Digital Inputs
.
Option:
Function:
[0]
No operation
[1]
Reset
[2]
Coast inverse
[3]
Coast and
reset inv
[4]
Quick stop
inverse
[5]
DC-brake
inverse
[6]
Stop inverse
[8]
Start
[9]
Latched start
[10]
Reversing
[11]
Start reversing
[12]
Enable start
forward
[13]
Enable start
reverse
[14]
Jog
[15]
Preset
reference on
[16]
Preset ref bit 0
[17]
Preset ref bit 1
[18]
Preset ref bit 2
5-12 Terminal 27 Digital Input
Functions are described in
parameter group 5-1* Digital Inputs
.
Option:
Function:
[19]
Freeze
reference
[20]
Freeze output
[21]
Speed up
[22]
Speed down
[23]
Set-up select
bit 0
[24]
Set-up select
bit 1
[28]
Catch up
[29]
Slow down
[34]
Ramp bit 0
[35]
Ramp bit 1
[44]
Restart Drive
[51]
External
Interlock
[55]
DigiPot
increase
[56]
DigiPot
decrease
[57]
DigiPot clear
[58]
DigiPot Hoist
[62]
Reset Counter
A
[65]
Reset Counter
B
[70]
Mech. Brake
Feedb.
[71]
Mech. Brake
Feedb. Inv.
[72]
PID error
inverse
[73]
PID reset I
part
[74]
PID enable
[75]
MCO Specific
[78]
Reset Maint.
Word
[80]
PTC Card 1
[91]
Profidrive
OFF2
[92]
Profidrive
OFF3
[94]
Light Load
Detection
[96]
Mains Loss
[97]
Mains Loss
Inverse
[98]
Start edge
triggered
[100]
Safe Option
Reset
Programming
Design Guide
MG80C602
Danfoss A/S © 05/2019 All rights reserved.
45
6
6
Summary of Contents for AHF 010
Page 2: ......
