Confi guration.
Access codes and
display
“Confi guration”
Access to reading of programme version and setting of access codes/
parameters concerning DANSETT logoff .
“Code no.”
Reading of AKA part No.
“Prog. ver.”
Reading of programme version
“Normal limit”
Setting of access level without using an access code. (A complete
menu survey is shown at the back of the manual).
Choose between the following settings:
1: No access to settings
2: Access up to and including “Time setting”.
3: Access up to and including “Confi guration”.
4. Access up to and including "System address".
5: Access to all menus
“Extended limit”
Setting of access level with the use of the “Extended code".
Choose between the following settings:
1: No access to settings
2: Access up to and including “Time setting”.
3: Access up to and including “Confi guration”.
4. Access up to and including "System address".
5: Access to all menus
“Extended code”
Setting of code to be keyed at logon, to obtain extended access.
“Service code”
Setting of code to be keyed at logon, to obtain service access (access to all
menu items).
“Dansett time”
Setting of time of automatic logoff . (If the gateway has not been operated
during this period, there will be logoff ). The time will be indicated in
seconds.
“Dansett logoff ”
Show the display possibility on AKA 21 of automatic logoff :
“Supervise mode”, “Select mode” or “Reset”. See next point.
“Change logoff ”
Selection of displays for “Dansett logoff ”. Setting = 2 should be used, if AKA
21 receives its power from an AKC controller or from an external power
pack:
0: “Supervise mode”: This setting can be used with advantage in small
systems.
When AKA 21 is not operated for, say, three minutes, the display will by
turns show access pictures on all connected controllers.
1: “Select mode”: AKA 21 shows the menu where DANBUSS unit is selected.
2: "Reset": AKA 21 shows "Dansett" ready, press any key”.
When a key is pushed, AKA 21 will show the menu where a DANBUSS
unit is selected.
Password
Settings can be protected with a password. The password can only be set
via the AKM programme version 4 (but may be deleted via AKA 21 without
it being known).
The password will protect against:
- reading of router lines and system confi gurations
- setting of router lines and alarm setups
AKA
245
Manual RS8DT102 © Danfoss 09/2004
27