32 DKDHR
VI.GP.V2.02
Danfoss District Energy
Instructions
Akva Lux II VX
Instructions
Akva Lux II VX
DHW recirculation
Substations with electronic control of the domestic hot water
circuit are prefabricated for DHW recirculation.
The circulation set is supplied assembled, incl. circulation pump
and electrically wired and ready to mount on the substation.
DHW circulation pump
The Akva Lux II VX3-E substations come standard with a Wilo-Star-Z
NOVA circulation pump, which is electrically connected to the ECL con-
troller from factory.
See chapter 14.2 on page 33 for more information about DHW
pumps.
13.0 Circulation pumps - Heating
The Akva Lux II VX2 and VX3 substations come standard with Wilo cir-
culation pump Wilo Yonos Para. If another pump type is used the Wilo
installation and operating instructions will be replaced by the installa-
tion and operating instructions for the pump in question.
Substation start-up / setting of pump
The pump is operated using the red operating knob. In turning the
knob the different control modes can be selected.
In a traditional radiator system the red operating knob must be set in
the left side control mode (1).
In floor heating systems and old radiator systems with large pipes and
radiators the red button must be set in the right side control mode (2).
Hereafter the pressure decreases to fit the building’s heating needs, - in
due consideration of cooling and power consumption.
Venting: The pumps have a built-in venting function, which can be
used when the system must be vented. To vent the system turn the
red button to select the symbol for air venting (middle position) (3),
after which the pumps run a venting routine of 10 minutes duration.
There may be noise during the air venting routine. When the 10 min.
has passed the pumps must be set according to the above instructions.
For more information please refer to enclosed installation and ope-
rating instructions:
Wilo Yonos Para
Installation and operating instructions
Installation and operating instructions Wilo-Yonos PARA 02/12
4523676
-01
The new standard in High Efficiency
GB:
Installation and operating instructions Wilo-Yonos PARA
1 General
About this document
The language of the original operating instructions is English. All
other languages of these instructions are translations of the original
operating instructions. These installation and operating instructions
are an integral part of the product. They must be kept readily
available at the place where the product is installed. Strict
adherence to these instructions is a precondition for the proper use
and correct operation of the product.
The installation and operating instructions correspond to the
relevant version of the product and the underlying safety regulations
and standards valid at the time of going to print. EC declaration of
conformity:
A copy of the EC declaration of conformity is a component of these
operating instructions (fig 8). If a technical modification is made on
the designs named there without our agreement or the declarations
made in the installation and operating instructions on
product/personnel safety
are not observed, this declaration loses its validity.
2 Safety
These operating instructions contain basic information which must
be adhered to during installation, operation and maintenance.
For this reason, these operating instructions must, without fail, be
read by the service technician and the responsible
specialist/operator before installation and operation.
It is not only the general safety instructions listed under the main
point “safety” that must be adhered to but also the special safety
instructions with danger symbols included under the following main
points.
Wilo-Yonos PARA
Wilo Yonos Para
1
2
3
