Setting up your Devireg 535 programmable thermostat with
your devimat system
Devireg 535
Selection of sensor type
Power on the thermostat
With the front off, with
a small screwdriver
or pencil press the
installation button.
Select the floor sensor
To change the default setting, press
l
and use the arrow buttons
to
select your choices. Press
l
to accept
your choice.
Press
for the next setting.
Maximum floor temperature.
- Tiles on timber based floor = 29°C
- Tiles on concrete based floor = 40°C
- Timber covered floors = 27°C
(parquet etc. - Please check with
floor supplier).
To change this setting, press
l
and
use the arrow buttons
to select
your choice. Press
l
to accept your
choice.
Press
for the next setting.
Scale
When selecting Celsius, the display
will show the actual temperature at
the floor sensor.
To change this setting, press
l
and
use the arrow buttons
to select
your choice.
Press
l
to accept your choice.
The installation procedure is now finished.
You can use the
for going back or forward through
the settings, otherwise:
Press the installation pinhole to exit
installation mode.
Put the frame and front back on.
You enter the settings by pressing the
pinhole with a small screw driver,
pencil, the display now changes from
temperature to time display.
By pressing the
l
, the hours starts
flashing - you can now change them
with the
.
Press the
l
again to change the
minutes with the
.
To finish, press
l
then
Setting the time
Setting the weekday
Mon Tue Wed Thu Fri
Sat Sun
By pressing the
l
, the weekday starts
flashing - you can now change them
with the
.
Press the
l
to accept.
To finish press
