Danfoss
ET9200 Hydraulic Hose Saw Operators’ Manual
BC444154783035en-000101
© Danfoss ET9200 Hydraulic Hose Saw Operators’ Manual | 2023.03. | 5
Changing the blade
1. Disconnect Power Plug & logout tagout.
2. Remove hex nuts (right) holding blade cover and remove cover.
3. Place 1⁄4 rod/pin through arbor shaft to lock saw blade arbor
shaft and drive pin at 12 o’clock (below left). This will lock the arbor
while the bolt is removed. Please note that the bolt (below right) to
remove the blade is left hand threaded. To remove it, turn counter-
clockwise.
4. Remove old blade and put new one on over the drive pin (below left) and arbor shaft. Be sure to follow the blade rotation
arrow (below right).
5. Placed clamping flange through drive pin and bolt blade
onto the shaft. Tighten bolt to 20-25 foot/lbs. Do not over-
tighten. Then remove 1⁄4 rod/pin which locks shaft.
6. Replace blade cover and tighten hex bolts.
