1.
Open protective cover (1).
2.
Position the bending pin (2) according to the hose diameter;
(see “Cutting the work piece” in Section 5).
3.
Position the work piece on the cutting plate between the bending
pin (2) and the hose feed (5).
4.
Close protective cover (1).
5.
Adjust the feed speed (4) to the middle of the scale (picture A).
6.
Switch on the machine using the main switch (3).
7.
Activate the foot pedal until the work piece is cut completely.
8.
Loosen the foot pedal and wait until the hose feed (5) has re-
turned completely.
Summary of Contents for ET9650
