1.
Close protective cover (7).
2.
Set the return stroke setting (6) to 0.
3.
Switch on the motor (1).
4.
Press the foot pedal (4) until the cutting fork (5) has reached the
lowest position.
5.
Release the foot pedal (4).
6.
Position the work piece on the side next to the cutting fork (5).
7.
Check whether the opening between the cutting fork (5) and the
cutting plate (3) is large enough for the work piece to pass
through.
8.
If necessary, increase the return stroke setting (6) in increments.
9.
Repeat steps 4
– 7 until the opening is large enough.
10. Switch off the motor (2).
WARNING!
Cutting risk
Once the motor has been switched off, the cutting knife will con-
tinue to run for a short time during which there is still a risk of cut-
ting your extremities.
•
Only open the protective cover once the cutting knife has
come to a complete standstill.
11. Open protective cover (7).
12. Remove the work piece.
