8
Ne
w Installa
tion
6. A small blanking plug is supplied to blank the unused
recessed bottom fi xing screw.
7. Before setting the programmes the unit should be
RESET
by pressing the recessed button marked
R/S
. Ensure the
mains power to the control circuit is switched on, and
check the circuits as follows.
8. Use the (Hot Water)
SELECT
button to get to the
ON mode to switch the hot water output
ON
. Adjust the
cylinder thermostat and check that the service operates
correctly. Use the
SELECT
button to get to
OFF
mode and
check that the service does not operate.
9. Use the (Heating)
SELECT
button to get to the
ON
mode to switch the heating output
ON
. Adjust any remote
thermostat(s) and check that the service operates correctly.
Use the
SELECT
button to get to
OFF
mode and check that
the service does not operate.
Summary of Contents for FP975
Page 1: ...FP975 Installation User Instructions 7 day electronic programmer Certification Mark...
Page 33: ...33...
Page 34: ...34...
Page 35: ...35...
