Application Guide | iC2-Micro Frequency Converters
P 5.8.8 Torque Limit Mode Speed Ctrl
Use this parameter to select an analog input for scaling the settings in
P 5.10.1 Torque Limit Motor Mode
and
P 5.10.2 Torque Limit
Generator Mode
0–100% (or inverse). The signal levels corresponding to 0% and 100% are defined in the analog input scaling. This
parameter is only active when
P 5.4.2 Configuration Mode
is in speed mode.
Default value:
0 [No Function]
Parameter type:
Selection
Parameter
number:
420
Unit:
–
Data type:
enum
Access type:
Read/Write
The following are the selections for the parameter.
Selection number
Selection name
0
No function
2
Analog in 33
4
Analog in 33 inverted
6
Analog in 34
8
Analog in 34 inverted
P 5.8.11 Band, High Limit
Some systems call for avoiding certain output speeds due to resonance problems in the system. Use this parameter, an array [4], to enter
the upper limits of the speeds to be avoided.
Default value:
0.0
Parameter type:
Range (Size Related)
Parameter
number:
463
Unit:
Hz
Data type:
uint16
Access type:
Read/Write
P 5.8.12 Band, Low Limit
Some systems call for avoiding certain output speeds due to resonance problems in the system. Use this parameter, an array [4], to enter
the lower limits of the speeds to be avoided.
Default value:
0.0
Parameter type:
Range (Size Related)
Parameter
number:
461
Unit:
Hz
Data type:
uint16
Access type:
Read/Write
Danfoss A/S © 2024.03 AB413939445838en-000301 / 130R1254 |
173
Summary of Contents for iC2
Page 1: ...iC2 Micro Frequency Converters Application Guide drives danfoss com...
Page 2: ......
Page 291: ......
