MCD 200 Series
MG.17.D3.02 – VLT is a registered Danfoss trademark
21
C
o
m
pon
ent
R
e
pl
acem
e
n
t
Disassembly Sequence 007~030
Step 1.
Remove plastic lid (complete with door) from
the body of the starter using the following procedure.
•
With the MCD 200 unit on its side, locate the
blade of a small flat bladed screw driver in one
of the four slots (2 each side) on the side of the
lid.
•
While ensuring the screw driver blade is pushed
into the deepest part of the slot (the edge
nearest the front face of the MCD 200) tap the
screw driver so that it is driven into the starter
5-10mm. This will release the clip securing the
lid the upper body moulding.
•
Repeat the above procedure for each of the
four clips.
Step 2.
Remove upper body moulding using the
following procedure.
•
With the MCD 200 unit on its side, locate the
blade of a small flat bladed screw driver in one
of the four slots (2 each side) on the side of the
upper body moulding.
•
While ensuring the screw driver blade is pushed
into the deepest part of the slot (the edge
nearest the heatsink of the MCD 200) tap the
screw driver so that it is driven into the starter
5-10mm. This will release the clip securing the
upper body moulding to the lower body
moulding.
•
Repeat the above procedure for each of the
four clips.
Step 3.
Access is now available to all sections of the
MCD 200. Component parts can now be removed
and replaced as required.
Step 4.
Reassemble the MCD 200 is reverse order.
ATTENTION
When refitting the upper body plastic
removed in Step 2 the following technique is
useful. Push in on the lower body cover at a point
next to the clip being located (1), while at the same
time pressing out and down on the upper body
cover at a point directly above the clip being secured
(2).
