Instructions
118A5495A - AN405821998738en-000102 | 45
© Danfoss | Climate Solutions | 2023.02 | LCA012A024
17 – Disposal
Only for Norway
Danfoss recommends that condensing units and oil should be recycled by a suitable company at its site.
When the condensing unit is relocated and reinstalled after moving to new address, or other, specialized techniques are required. Consult your
dealer or specified contact desk of maker.
When disposing the condensing unit, although it is not necessary to collect the refrigerant, consult your dealer or specified contact desk of maker.
Only for European Union and countries with recycling systems
This symbol on the products, packaging, and/or accompanying documents means that used electrical and electronic products must not be mixed with general
household waste.
For proper treatment, recovery and recycling of old products, please take them to applicable collection points in accordance with your national legislation.
By disposing of them correctly, you will help to save valuable resources and prevent any potential negative effects on human health and the environment.
For more information about collection and recycling, please contact your local authority.
Penalties may be applicable for incorrect disposal of this waste, in accordance with national legislation.
18 – Servicing
Accessories
Name
Q’ty
Location of use
Wiring
3
Connect these to CNG1, 2 or CNS3 on the outdoor unit
PCB when external inputs are used.
These are fixed in the control box with tapes.
When using the wiring, refer to the “External input
harness installation manual”, page 46.
Wiring
2
When using external outputs, cut the harness at the
center to produce a pair of connectors, and connect
them to CNH, CNY, CNZ1 and CNZ2 on the outdoor unit
PCB.
These are fixed in the control box with tapes.
When using the wiring, refer to the “External output
harness installation manual”, page 47.
Dryer
1
Install in liquid pipe. Dryer pipe diameter need to
reduce with reducer to connect liquid pipe.
This is fixed to unit base plate with tapes.
Reducer (for dryer)
2
Connect to dryer pipe.
These are fixed to unit base plate with tapes.
Reducer (for service port)
3
Using for airtight test and vacuuming. Connect to
service port.
"These are fixed to unit base plate with tapes.
When using the reducer, refer to the page 12-13 of In-
structions “Leak detection” and "Vacuum dehydration"."
