Installation
JS1-H Steer by Wire Connector interface
The JS1-H Steer by Wire comes with a single connector interface option. As introduced by the joystick’s
safety concept, both channels run independently. This is also reflected by the connector interface; there
is one physical connector for each of the two channels.
C1 pin
Function
Diagram
1
Ground (common)
2
Power supply A
3
Steering Bus A-H
4
Steering Bus A-L
5
CAN Shield A
6
FF Power
7
Horn Signal
8
Horn Power
C1 pin
Function
Diagram
1
Ground (common)
2
Power supply B
3
Steering Bus B-H
4
Steering Bus B-L
5
CAN Shield B
6
NC
Please refer to the JS1-H Steer by Wire data sheet for further inforation on technical details.
for further
User and Safety Manual
PLUS+1® JS1-H Steer by Wire
System Set-up
20 |
©
Danfoss | December 2022
AX436683569858en-000101
