231 of 282
M-SV-001-EN Rev. G
7. Leak test and evacuate compressor in accordance with standard industry practices.
8. Install the bearing sensor cable onto the new 9-pin feed through.
9. Carefully, insert the BMCC back into its slot. Align the BMCC module’s two (2) lower guides
so they are aligned on the inside of the Bearing PWM module’s two upper guides. Note the
insertion guides shown in "Figure 4-294 BMCC Insertion Guides".
10. Carefully, insert the Serial Driver back into its slot. Align the serial driver module’s two lower
guide rails so that they are aligned on the inside of the BMCC module’s two upper guide rails.
Refer to "Figure 4-294 BMCC Insertion Guides".
Figure 4-294 BMCC Insertion Guides
11. Install the Service Side Cover. "4.2.3.1 Service Side Cover Removal and Installation" on page
12. Install the top covers. Refer to "4.2 Compressor Covers" on page 56.
13. Return the compressor to normal operation.
4.31.5.3 Bearing Sensor Torque Specifications
Table 4-50 Bearing Sensor Torque Specifications
4.32 Cavity Temperature Sensor
4.32.1 Cavity Temperature Sensor Function
The Cavity Temperature sensor reads the temperature of the motor cooling gas within the shaft cavity
as it exits the Stator.
Figure 4-295 Cavity Sensor
SERIAL DRIVER
BEARING MOTOR COMPRESSOR CONTROLLER (BMCC)
BEARING PWM
Description
Nm
Ft.Lb.
In.Lb.
Bearing Sensor Feedthrough fastener, M5x16
5
-
44
Cover fastener, M5x15
1.5
-
13
Summary of Contents for Turbocor TTS Series
