Procedure
1. In
Security
submenu, push the Menu button Right.
2. To go to the edit mode, push the Menu button Right.
The display shows
0
that blinks.
3. There are 2 options to set a password: with the Browser buttons or by digits. The password can be a number between 1 and 65535.
- With the Browser buttons: Push the Browser buttons Up and Down to find a number.
- By digits: Push the Menu button Right. A second
0
shows on the display.
•
Push the Browser buttons to set digit on the right.
•
Push the Menu button Left, and set the digit on the left.
•
To add a third digit, push the Menu button Left. Set up to 5 digits with Menu and Browser buttons and set the digit for each
one with the Browser buttons.
4. To accept the new password, push the [enter] button.
The password activates after the Timeout time (P6.6.3) (see
8.7.7.4 Setting the Timeout Time
).
8.7.6.4 Entering a Password
Context:
In a password-protected submenu, the display shows
Password?
Use these instructions to enter the password.
Procedure
1. When the display shows
Password?
, give the password with the Browser buttons.
8.7.6.5 Deactivating the Password Function
Context:
Use these instructions to deactivate the password protection for application selection menu.
Procedure
1. Find the
Password
(
S6.5.1
) in the
Security
menu with the Browser buttons.
2. To go to the edit mode, push the Menu button Right.
3. Set value
0
for the password.
8.7.6.6 Locking a Parameter
Context:
Use the Parameter lock function to prevent changes to the parameters. If the parameter lock is active, the text
locked
shows on the
display when trying to edit a parameter value.
NOTICE
This function does not prevent unauthorized changes of parameter values.
Using the Control Panel
Operating Guide | VACON® NXS/NXP Air-cooled
AQ275638903263en-000301 / DPD00910| 131
Danfoss A/S © 2020.02
