5 How to operate the adjustable frequency drive
5.1.1 Ways of Operation
The adjustable frequency drive can be operated in 3 ways:
1.
Graphical Local Control Panel (GLCP), see 6.1.2
2.
Numeric Local Control Panel (NLCP), see 6.1.3
3.
RS-485 serial communication or USB, both for PC connection, see 6.1.4
If the adjustable frequency drive is equipped with the serial communication option, please refer to the relevant documen-
tation.
5.1.2 How to operate the Graphical LCP
(GLCP)
The following instructions are valid for the GLCP (LCP 102).
The GLCP is divided into four functional groups:
1.
Graphical display with Status lines.
2.
Menu keys and LEDs - selecting mode, changing
parameters and switching between display
functions.
3.
Navigation keys and LEDs (LEDs).
4.
Operation keys and LEDs.
Graphical display:
The LCD display is back lit with a total of 6 alpha-numeric
lines. All data is displayed on the LCP, which can show up
to five operating variables while in [Status] mode.
Display lines:
a.
Status line: Status messages displaying icons and
graphics.
b.
Line 1-2: Operator data lines displaying data and
variables defined or chosen by the user. By
pressing the [Status] key, up to one extra line can
be added.
c.
Status line: Status messages displaying text.
The display is divided into 3 sections:
Top section (a)
shows the status when in status mode, or up to two
variables when not in status mode and in the case of an
alarm/warning.
Auto
on
Reset
Hand
on
Off
Status
Quick
Menu
Main
Menu
Alarm
Log
Back
Canc
el
In
fo
OK
Status
1(0)
1234rpm
10,4A
43,5Hz
Run OK
43,5Hz
On
Alarm
Warn.
130BA018.13
1
2
3
4
b
a
c
The number of the Active Set-up (selected as the Active
Set-up in par. 0-10) is shown. When programming in
another set-up than the Active Set-up, the number of the
set-up being programmed appears to the right in brackets.
How to operate the adjustab...
VLT AQUA 12-Pulse High Power Instruction Manual
MG.20.Y1.22 - VLT
®
is a registered Danfoss trademark
5-1
5
5
