Choose a parameter group from the main menu and press
[OK]. Then further select the parameter sub-groups by
using the up and down arrows and then press [OK].
The middle section of the keypad display shows the
parameters. Press [OK] to select the parameters; the display
now shows the selected parameter's value.
130BP067.10
740RPM
0 -01 Language
[0] English
10.64A
1 [1]
0-0*
Basic Settings
Figure 5.2 Display example.
5.1.5 Changing a Group of Numeric Data
Values
If the chosen parameter represents a numeric data value,
change the chosen data value by means of the [
◄
] and [
►
]
navigation keys as well as the up/down [
▲
] [
▼
] navigation
keys. Use the
◄
] and [
►
] navigation keys to move the
cursor horizontally.
130BP069.10
1- 6*
113 RPM 1.78 A 1(1)
Load depen. setting
1 - 60 Low speed load
compensation
1
0
0%
Figure 5.3 Display example.
Use the up/down navigation keys to change the data
value. The up key increases the data value, while the down
key reduces it. Place the cursor on the value to be saved
and press [OK].
130BP070.10
1 - 60 Low speed load
compensation
1 0%
Load depen. setting
1- 6*
729RPM
6.21A 1(1)
6
Figure 5.4 Display example.
5.1.6 Changing Data Values, Step-by-Step
Certain parameters can be changed step-by-step or by an
infinite number of variables. This applies to
,
and
The parameters are changed both as a group of numeric
data values, and as numeric data values using an infinite
number of variables.
5.1.7 Readout and Programming of
Indexed Parameters
Parameters are indexed when placed in a rolling stack.
15-30 Alarm Log: Error Code
to
15-32 Alarm Log: Time
contain a fault log which can be read out. Choose a
parameter, press [OK], and use the up/down navigation
keys to scroll through the value log.
Use
as another example:
Choose the parameter, press [OK], and use the up/down
navigation keys to scroll through the indexed values. To
change the parameter value, select the indexed value and
press [OK]. Change the value by using the up/down keys.
Press [OK] to accept the new setting. Press [Cancel] to
abort. Press [Back] to leave the parameter.
How to operate the adjustab...
VLT AQUA 12-Pulse High Power Instruction Manual
MG.20.Y1.22 - VLT
®
is a registered Danfoss trademark
5-5
5
5