130B
T308.10
Figure 5.6 For control cable connections, see section on
Control
Terminals
.
5.1.13 PC Software Tools
PC-based Drive Control Tool DCT 10
All adjustable frequency drives are equipped with a serial
communication port. Danfoss provides a PC tool for
communication between PC and adjustable frequency
drive, PC-based Drive Control Tool DCT 10. Please check
the section on
Available Literature
for detailed information
on this tool.
Drive Control Tool DCT 10
DCT 10 has been designed as an easy to use interactive
tool for setting parameters in our adjustable frequency
drives. .
The DCT 10 Drive Control Tool will be useful for:
•
Planning a communication network off-line. DCT
10 contains a complete adjustable frequency
drive database
•
Commissioning adjustable frequency drives
online.
•
Saving settings for all adjustable frequency drives.
•
Replacing an adjustable frequency drive in a
network.
•
Simple and accurate documentation of adjustable
frequency drive settings after commissioning.
•
Expanding an existing network
•
Adjustable frequency drives developed in the
future will be fully supported.
Drive Control Tool DCT 10 software supports Profibus DP-
V1 via a master class 2 connection. This makes it possible
to access read/write parameters online in an adjustable
frequency drive via the Profibus network. This will
eliminate the need for an extra communication network.
Save adjustable frequency drive settings:
1.
Connect a PC to the unit via USB com port.
(NOTE: Use a PC, which is isolated from the line
power, in conjunction with the USB port. Failure
to do so may damage equipment.)
2.
Open Drives Control Tool DCT 10 Software
3.
Choose “Read from drive”
4.
Choose “Save as”
All parameters are now stored on the PC.
Load adjustable frequency drive settings:
1.
Connect a PC to the adjustable frequency drive
via the USB com port
2.
Open Drives Control Tool DCT 10 software
3.
Choose “Open” – stored files will be shown
4.
Open the appropriate file
5.
Choose “Write to drive”
All parameter settings are now transferred to the
adjustable frequency drive.
A separate manual for Drives Control Tool DCT 10 Software
is available
from GE or the website: www.geelectrical.com/
drives
.
The Drives Control Tool DCT 10 software modules
The following modules are included in the software
package:
DCT 10 Software
Setting parameters
Copy to and from adjustable frequency drives
Documentation and print out of parameter
settings incl. diagrams
Ext. user interface
Preventive Maintenance Schedule
Clock settings
Timed Action Programming
Logic Controller Set-up
Ordering number:
Please contact GE or visit: www.geelectrical.com/drives
How to operate the adjustab...
VLT AQUA 12-Pulse High Power Instruction Manual
5-8
MG.20.Y1.22 - VLT
®
is a registered Danfoss trademark
5
5
