Procedure
1. Press [Hand On].
2. Move the left cursor to the left of the decimal point by using the left arrow key.
3. Enter an RPM that slowly rotates the motor and press [OK].
The motor runs briefly at either 5 Hz or the minimum frequency set in
parameter 4-12 Motor Speed Low Limit [Hz]
.
4. If the motor rotation is wrong, set
parameter 1-06 Clockwise Direction
to
[1] Inverse
.
6.4.2 Testing Encoder Rotation
Context:
Use this procedure if encoder feedback is used. For more information on the encoder option, refer to the option manual.
Procedure
1. Select
[0] Open Loop
in
parameter 1-00 Configuration Mode
.
2. Select
[1] 24 V encoder
in
parameter 7-00 Speed PID Feedback Source
.
3. Press [Hand On].
4. Press [
►
] for positive speed reference (
parameter 1-06 Clockwise Direction
at
[0] Normal
).
5. Check feedback in
parameter 16-57 Feedback [RPM]
.
- If feedback is positive, the test was successful.
- If feedback is negative, the encoder connection is wrong. Use either
parameter 5-71 Term 32/33 Encoder Direction
or
parameter
17-60 Feedback Direction
to inverse the direction, or reverse the encoder cables.
Parameter 17-60 Feedback Direction
is only available
with the VLT® Encoder Input MCB 102 option.
6.5 Starting Up the Drive for the First Time
Context:
The procedure in this section requires user-wiring and application programming to be completed. The following procedure is
recommended after application setup is completed.
WARNING
MOTOR START
Starting the drive can cause the motor to start. Failure to ensure that the motor, system, and any attached equipment are ready
for start can result in personal injury or equipment damage.
-
Ensure that equipment is safe to operate under any condition.
-
Ensure that the motor, system, and any attached equipment are ready for start.
Starting the Drive
Operating Guide | VLT® AQUA Drive FC 202
AQ275652274277en-000101 / 130R0708| 71
Danfoss A/S © 2020.01
Summary of Contents for VLT AQUA Drive FC 202
